Introduction
This following is an introduction to the Key Steps in Tree Safety Management as proposed by the National Tree Safety Group in their guidance document Common sense risk management of trees. It is intended for landowners of estates and smallholdings and all those who manage, advise and work on them.
Responsibility
A tree belongs to and is the responsibility of whoever controls the land on which the tree is growing, usually the landowner, though it may be controlled by an agent or tenant by written agreement.
A tree owner has a responsibility in law known as the ‘duty of care’. When a tree owner fails to exercise his or her responsibility and harm or injury results, the tree owner may be subject to a claim for negligence.
Key Steps in Tree Safety Management
The seven ‘Key Steps in Tree Safety Management’, for a landowner, as follows:
A Tree Strategy
A tree strategy is a plan that guides management decisions and practice, in a reasonable and cost-effective way.
Keeping Records
Records provide the basis for tree safety management reviews and can support evidence of reasonable tree management.
Zoning
Zoning is a practice whereby landowners and managers define areas of land according to levels of use. This practice prioritises the most used areas and focusing resources where most needed.
Trees within Falling Distance of Roads, Railways etc.
The greatest risk to public safety is from trees within falling distance of where people move at speed in vehicles. It is both the high usage of roads and the speed at which people travel along them that makes this scenario the most frequent cause of death or serious injury involving trees.
Trees in Infrequently Used Areas
The risk of death or serious injury from trees in infrequently used areas is so low that it is reasonable that these should receive no formal inspection or visual check. However, owners should to respond to reports of problems.
Observations and Inspections
The three types of observations/inspections as follows:
Informal observations are day-to-day observations made by owners and employees of a site who have good local knowledge of the trees and the location and see them during the course of their daily lives and work.
Formal inspection is when a specific visit to the tree is made with the sole purpose of performing an inspection that is not incidental to other activities.
Detailed inspection should be applied for individual, high-value trees giving high-priority concern in well-used zones. The detailed inspection is normally prioritised according to the level of safety concern.
Balance
Tree safety management decisions need to balance hazard, risk and target with benefits.
